Penetration repair
Pipes and conduit get new boots or field-wrapped flashing welded to the field sheet.
Flat Roofing
TPO Roof Repair Paramus, NJ
Most leaks in a TPO roof in Paramus start at a seam, a penetration or a puncture, and a roofer can weld those closed, as long as the membrane is still flexible enough to take a weld. Dial (551) 383-2304 to talk with a local roofer about the leak.
Most TPO leaks come from a handful of spots, and each has a standard fix. Open laps are common, often from a cold weld at install or a corner where the sheets meet in a T-joint. Punctures from dropped tools, hail or foot traffic around equipment are the other big source, along with flashings that pull away at curbs, walls and pipes.
A proper TPO repair is welded, not glued. An aged sheet must be cleaned with a weathered membrane cleaner so the hot-air welder can fuse the patch to it. If the membrane cracks when it is folded or will not take a weld, the roofer may recommend a larger patch or a recover instead.
The drip inside is rarely right below the hole. Water can travel across the top of the insulation or along the flutes of a steel deck before it finds a gap to drip through. Note where and when it drips, whether in every rain or only in wind-driven storms, and whether anyone has worked on the roof lately. Keep water away from light fixtures and outlets, and switch off that circuit at the panel if you can do so safely.
Depending on what the roofer finds, tpo roof repair in Paramus, NJ can go hand in hand with tpo roofing and flat roof repair.
Dealing with this in Paramus, NJ right now? Call (551) 383-2304 to talk to a local roofer.
Call nowThe process
The TPO repair process
Lasting TPO repairs follow a clear order.
Find the source
Interior stains are matched to the roof above, then the roofer checks every seam, curb and penetration in that area. A probe along the seams finds cold welds, and a controlled water test can confirm a suspected spot.
Open the area
A core sample near the leak tells the roofer how far the water has spread through the insulation. Wet boards are cut out and replaced so they do not stay trapped under the patch.
Prep the membrane
The roofer cleans the weathered surface until fresh membrane shows. Some roofers run a small test weld first to check the membrane.
Weld the repair
Open seams are rewelded or covered with a strip of new TPO, and punctures get a patch with rounded corners that extends well past the damage. Where seams cross in a T-joint, a round patch covers the step in the lap.
Redo the flashings
Loose base flashing at walls is refastened, cracked boots are replaced and sealant at pitch pans is renewed. Drain clamping rings are tightened or replaced so water cannot slip under the membrane at the drain.
Probe the finished work
Finished welds are probed to make sure there are no gaps. A short note of what was found and fixed, with locations, is worth keeping for future repairs.
What is included
TPO repairs a roofer can handle
Wet insulation replacement
Insulation that has taken on water is replaced so moisture is not trapped below.
Puncture patches
Holes and cuts are covered with welded TPO patches sized well past the damage.
Open lap repair
Seams that fail the probe are rewelded or stripped in with a cover strip where the edge is damaged.
Wall flashing repair
Split corners at curbs are patched and walls reflashed so wind cannot get under it.
Related service
TPO Roof Maintenance Paramus, NJ
TPO roof maintenance is mostly about keeping water moving and catching small damage before it spreads. Good upkeep means spring and fall checks of the laps, flashings and drains, and a look after strong storms. Leaves, debris and loose screws left by service techs should come off the roof, since they block drains and puncture the sheet.
Where service techs cross the roof often, walkway pads keep boots and tools off the membrane. Washing the membrane every few years with a mild cleaner and a soft brush keeps it reflective and makes later repairs weld better. Keeping a log of every visit helps a Paramus owner spot repeat problems early.
Local help
TPO Roof Repair Near Me
Around Paramus, most TPO leaks show up at seams, curbs and pipe boots rather than in the open field of the roof. From Paramus out to Oradell, River Edge, Fair Lawn and New Milford, older TPO sheets tend to need cleaning and careful prep before a patch will weld, so regular checks keep small punctures from turning into wet insulation.
Searching for tpo roof repair near me from Paramus or Oradell, River Edge, Fair Lawn and New Milford? Call (551) 383-2304 to talk to a roofer who works in your part of town.
How the weather here affects roofs around Paramus
Cold winters bring snow, ice and a long stretch of freezing nights. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, which is how ice dams form and back water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. That is why roof repair in Paramus is busiest after a hard winter and before the next one.
Why call
Why act early
Smaller repairs
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Local knowledge
Local roofers see the same roofs and storm damage across Paramus and nearby towns.
Straight answers
Ask your questions before you agree to anything.
TPO Roof Repair FAQ
Can I go up on my TPO roof to look for the leak?
The membrane handles normal walking, though roof access carries real risk. Never climb onto a wet, icy or storm-damaged roof, since wet TPO is slick and flat roofs often lack edge protection. Skylights and soft insulation areas are added hazards, so the roofer is better placed to search.
Why does my TPO roof leak at the seams?
Most seam failures trace back to the original weld. A cold or rushed weld can hold for a while, then open as the roof expands and contracts with temperature. T-joints and corners are the most common trouble spots.
Will a TPO patch hold up?
A properly welded patch becomes part of the membrane and can last as long as the sheet around it. Repairs that skip the cleaning step, or that rely on caulk, tend to fail within a few seasons. Repeat leaks in one area point to something else, such as a flashing or trapped water.
How is a hole in a TPO roof fixed?
A puncture or open seam in TPO is fixed by welding a patch of new membrane over it. The old sheet is cleaned first so the patch fuses, and the patch extends a few inches past the damage on every side with rounded corners. Tape and caulk are short-term fixes; the weld is what lasts.
Should I repair or replace my TPO roof?
Repair makes sense when leaks are few, the membrane is still flexible and the insulation is mostly dry. If the membrane cracks when folded, will not take a weld or covers a lot of wet insulation, replacement or a recover is likely. A moisture survey and a test weld settle most cases.
More questions? Call (551) 383-2304
Related services
TPO Roofing
Heat-welded TPO membrane for flat and low-slope roofs, sized to the deck, the drains and the way the roof is used.
Learn moreFlat Roof Repair
Flat roof repairs matched to the membrane, whether EPDM, TPO, PVC, modified bitumen or built-up, with the patch made from material that bonds to what is there.
Learn moreCommercial Roof Repair
Fixing leaks over stores, offices, warehouses and apartment units, so damage stays small.
Learn moreRoof Coating
Silicone, acrylic and other liquid coatings that renew aging flat, low-slope and metal roofs, when the roof underneath is still dry and solid.
Learn more
Looking for something else?
See all roofing servicesNeed tpo roof repair in Paramus, NJ?
Call (551) 383-2304 for a local roofer in Paramus and nearby towns.